Gutter Downspout Splash Installation Instructions

From the foundation or to an underground catchment system 10 ft.

Gutter downspout splash installation instructions. Next mark the locations of the downspouts with an x. Be sure to practice ladder safety. Use utility scissors or a box cutter to cut along the line that s factory marked on the extension. Begin measuring the roofline where the gutter will be installed adding together the lengths of each fascia.

Mark the measurements and make an outline on graph paper. Install adequately sized gutters and downspouts. Step 3 cut the end off the extension that will not be connecting to the downspout. Connect the downspouts to piping that will carry the water to a sloping final grade 5 ft.

Adjust the angle of the splash block to ensure it slopes down and away from not toward the house. When measuring be sure to start from the ground and end at the flat of the gutter. Attach a 5 inch downspout pipe to the drop outlet using a coupler. Subtract 6 to 7 inches and this will become the length of the downspout.

The ideal angle is a slope of 6 inches in 10 feet. Continue reading below our video of the day. Take the measurement from the outer edge of the shingle. From the foundation that is not connected with the foundation drain system epa indoor airplus.

Then place another elbow flush against the wall with one end facing outward and the other pointing downwards. Measure the distance from the drain point of the rain gutter to the ground. Unkink and straighten before installation to avoid breaking the extension or pulling it off the downspout. Install front screws holding spout tightly up against bottom of gutter install two zip screws through front flange on spout into front of gutter.

You may need to do some digging. Once the downspout extension is cut it is ready to connect. The spout gutter outlet installation is complete. All work up at gutter is done.